canufrank

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • canufrank
    Participant

    1. `sysctl -n machdep.cpu.brand_string
    Genuine Intel (R) CPU 1500 @ 2.00 GHz`

    Doesn’t say Core Duo, but it is one

    2. `sysctl hw.cpu64bit_capable
    hw.cpu64bit_capable: 0`

    I never noticed the 64 bit requirement. Thanks Zag.

    in reply to: Unable to configure router #10817
    canufrank
    Participant

    “NoMachine would list your public IP if you had enabled UPnP”

    What I was expecting was that NoMachine would test if it could communicate on that port, and if it could, would display the IP:port combination.

    So, because, NoMachine was only displaying the local port, I assumed that it wasn’t getting communications. I never actually tested connectivity. Once I did, I could connect from the WAN with no issue. So, I’m happy about that 🙂

     

    I would suggest that if port 4000 or whatever the user has set it to are already open, the Connection Status window should reflect that- it hardly matters whether or not UPnP is enabled.

    Similarly, if the user clicks GW and the (uneditable prefilled) port is found to be already open, there should never be an error message, as it doesn’t matter that the application cannot map the port.

    Finally, the GW port should be made editable if UPnP is not being employed (an additional check box too).

    canufrank
    Participant
    sw_vers
    ProductName: Mac OS X
    ProductVersion: 10.6.8
    BuildVersion: 10K549
    
    uname -a
    Darwin frank 10.8.0 Darwin Kernel Version 10.8.0: Tue Jun  7 16:33:36 PDT
    2011; root:xnu-1504.15.3~1/RELEASE_I386 i386

    Log attached

    Attachments:
Viewing 3 posts - 1 through 3 (of 3 total)