sona1111

[sona1111]

I appreciate the very helpful links, however this has still not helped with the issue.

I have:

-opened port 4000 (security group)

-installed the desktop enviros

-installed nx by copying over the folder and using dpkg as described here: https://www.nomachine.com/DT09K00056&documentName=

-followed these instructions kindly provided by you: https://www.nomachine.com/AR10K00710

at this point I did get a few errors which I am not sure are critical :

Could not init font path element /usr/share/fonts/X11/100dpi/:unscaled, removing from list!
Could not init font path element /usr/share/fonts/X11/75dpi/:unscaled, removing from list!
Could not init font path element /usr/share/fonts/X11/100dpi, removing from list!
Could not init font path element /usr/share/fonts/X11/75dpi, removing from list!

at the nx client, configured to password auth, NX, port 4000, I still get :

Could not connect to the server.

Error is 5: Input/output error

As before this seems strange because it does not ‘try’, the error comes immediately: it does not seemingly take the time to get to the network at all. Possibly I am wrong but this seems to be how it is.

Also I can verify port 4000 is open:

telnet <ip_address> 4000

I have also verified that the service is started on the server, and I have rebooted the server and re run the commands in the article above, just to be sure, still same issue.

If you have any other suggestions, I would greatly appreciate it.

[Author]

Posts